The BE Pressure HW2765HG is a portable hot-water gas pressure washer built around a Honda GX200 commercial engine and a General Pump TP2530 triplex pump, delivering 2,700 PSI at 2.8 GPM with a diesel-fired Wayne burner that pushes water temperature up to 193 degrees F. The combination puts a full hot-water washer on a single tow-friendly frame for fleet, food-service, agricultural, and contractor wash-down work where cold water alone cannot break degreaser bonds.
Built for
Fleet truck wash bays, restaurant and commercial kitchen hood and grease cleanup, agricultural equipment degreasing, dairy and food-processing sanitation prep, construction equipment cleanup, oil and lube facility floors, and any cleaning operation where hot water breaks animal fat, road tar, or hydraulic fluid that cold water leaves behind.
Why hot water at 193 deg F matters
Hot water dissolves grease, animal fat, road tar, and hydraulic oil that a cold-water washer at the same PSI cannot touch. The HW2765HG's adjustable thermostat lets the operator dial water temperature up to 193 deg F at the nozzle - hot enough to cut through most commercial degreaser jobs without burning landscaping or workers, and hot enough that fewer chemical detergents are needed.
Honda GX200 engine and General triplex pump
The Honda GX200 is the commercial pressure-washer standard for a reason: it starts every time, runs fuel-efficiently for hours, and is supported by a worldwide service network. Paired with the General Pump TP2530 - die-cast body, forged brass manifold, one-piece plungers, thermal release valve, external unloader for cooler running and easier service - this is a duty-cycle pump that holds up to 8-hour days on a fleet wash crew.
Burner and heating coil
The 12V Wayne diesel burner heats water through a 1/2-inch cold-rolled steel heating coil. The 6-gallon fuel tank gives roughly 4 hours of burner run-time on a fill. The adjustable thermostat lets the operator stage cold rinse, warm wash, and hot degrease without shutting the machine down.
Specifications
- Output: 2,700 PSI at 2.8 GPM
- Engine: Honda GX200 (3.1 qt fuel capacity)
- Pump: General Pump TP2530 triplex
- Burner: 12V Wayne diesel-fired, 1/2-inch cold-rolled steel coil
- Max water temp: 193 deg F (89 deg C)
- Burner fuel tank: 6 gallon
- Included: 50-foot high-pressure hose, spray gun and wand assembly, 5 spray nozzles
Frequently asked questions
How long does a tank of burner fuel last?
The 6-gallon diesel burner tank gives approximately 4 hours of continuous burner run-time, longer if you stage cold rinse and warm wash cycles between hot-water passes.
Can I run the HW2765HG cold if I don't need heat?
Yes. Shut the burner off and the machine runs as a 2,700 PSI cold-water washer. This is the standard mode for general rinsing and final spot-free passes.
What detergents are compatible?
Use commercial hot-water-rated alkaline degreasers for fleet and food-service work, acid-based products for mineral and rust removal. Avoid bleach-based detergents in the high-pressure side - they damage seals. Always rinse the chemical line between products.
Does this need a special water supply?
A standard 3/4-inch garden hose at residential pressure (40-80 PSI) feeds the inlet. For continuous duty in remote locations, plumb to a 100-gallon supply tank with a float valve.
How does it compare to the BE HW3565HG or HW4015HG?
The HW2765HG is the 2,700 PSI Honda GX200 entry point. The HW3565HG steps up to 3,500 PSI for heavier degreasing, and the HW4015HG is the 4,000 PSI commercial-fleet machine. Pick the HW2765HG for restaurant, dairy, and small-fleet work; step up if you are doing full commercial fleet wash bays.
Discount Cleaning Products is an authorized BE Power Equipment dealer. The HW2765HG ships from BE with factory warranty support, and our US-based customer service team can help match burner fuel, replacement spray nozzles, and detergent staging for your specific wash operation.