Keep your BE Pressure TP-3065HR 3" semi-trash pump sealed tight and ready to work with this replacement drain and prime plug set. Built for contractors, rental yards, landscape crews, and restoration operators who run the TP-3065HR for job-site dewatering and water transfer, this two-plug set restores the watertight seal on the pump housing when the factory plugs strip, crack, or lose their sealing gasket from repeated field use.
Every BE 2-3" semi-trash pump housing has two threaded ports: a prime port used to fill the pump casing with water before startup so the pump can build suction, and a drain port used to empty the casing after use. Both plugs thread into the cast housing and rely on a sealing gasket to hold pressure and keep grit and moisture out between jobs.
Built for:
- Sealing the prime port after filling the pump casing ahead of startup
- Sealing the drain port for end-of-job drain-down, transport, or winter storage
- Replacing a stripped, cracked, or leaking factory plug that won't hold a seal
- Keeping the housing sealed against dirt and moisture intrusion between uses
Specifications
- Fits: BE Pressure TP-3065HR 3" semi-trash transfer pump (Honda GX200)
- Includes: both plugs in the set - drain plug and prime plug
- Thread: pipe-style threads sealed with a gasket; hand-thread and snug with a wrench, do not overtighten into the aluminum housing
Frequently asked questions
What is each plug used for?
The prime plug covers the port you open to fill the pump casing with water before starting the engine, which the pump needs to build suction. The drain plug covers the port used to empty the casing after a job, before transport, or ahead of winter storage.
When should I replace these plugs?
Replace both plugs when the threads are stripped or cross-threaded, a plug is cracked, the sealing gasket is missing or hardened, or the housing leaks or won't hold prime even after the plug is reinstalled and snugged.
What thread and install type do these use?
Both plugs use pipe-style threads sealed by a gasket, matching the BE Pressure TP-3065HR pump housing. Hand-thread each plug into its port and snug with a wrench; avoid overtightening, which can crack the cast housing or damage the threads.
Discount Cleaning Products is an authorized BE Pressure dealer with US-based service and support, stocking genuine replacement parts to keep your BE equipment running.
