The BE Pressure telescoping wand belt kit (85.400.019) takes the weight of a fully extended telescoping wand off your arms and puts it on your hips and shoulders. For anyone washing second and third-story siding, gutters, or soffits from the ground, it is the difference between steering the wand and fighting it.
Use cases
Exterior cleaning contractors use the belt kit for two and three-story house washes, gutter and soffit cleaning, and commercial facade work where a telescoping wand runs extended for an hour or more at a time. Property-maintenance staff use it to make occasional high work safer and less exhausting, since a supported wand is steadier and easier to control at full extension.
How it works
The kit combines a padded waist belt and shoulder strap with a metal wand clamp. Clamp the bracket at the wand's balance point, clip in, and the wand's weight transfers to your torso while your hands steer. Adjustment clips customize the fit at the waist and shoulder, and the rig works for right-handed or left-handed operators. Note that the kit is a fatigue-reduction support only - it does not provide back support or fall protection.
Specifications
- Fits all BE long and telescoping wands
- Waist belt plus shoulder strap with adjustment clips
- Metal wand clamp - position anywhere along the wand for best balance
- Right-handed or left-handed use
- Weight: approximately 3 pounds
- 90-day consumer and commercial warranty
Fitting and field tips
Set the wand clamp slightly behind the wand's balance point so the tip floats up naturally - you steer down into the work instead of holding weight up all day. Fit the waist belt snug on your hips, not your waist, so your skeleton rather than your lower back carries the load, then take up the slack in the shoulder strap. Most operators find their sustainable working time at full extension doubles or better once the belt is dialed in, and wand control improves noticeably because small corrections no longer fight gravity.
The kit packs flat in a truck box and moves between operators in seconds thanks to the adjustment clips, so one belt can serve a whole crew across a day of mixed jobs. Pair it with a fan-tip nozzle and downstream injector for soft-wash siding work, where long dwell passes at height are exactly the work that wears arms out fastest.
If you are buying your first telescoping wand at the same time, order the belt with it - nearly everyone who works at height more than once a month ends up adding one eventually, and learning wand control with the belt from day one builds better habits than retrofitting it after the first exhausting two-story job.
Frequently asked questions
Which wands does the belt kit fit?
It fits all BE long and telescoping wands - the metal wand clamp adjusts along the pole so you can set it at the balance point of any length wand.
Can left-handed operators use it?
Yes. The waist and shoulder straps adjust for either right-handed or left-handed use.
Does it provide back support or fall protection?
No. The kit transfers wand weight to your torso to reduce arm and shoulder fatigue, but it is not a back-support device and provides no fall protection.
How does the kit actually help on a long job?
A fully extended telescoping wand is heavy and front-loaded. The belt carries that weight at your hips and shoulder, so your arms only steer - operators routinely work two and three-story washes far longer without strain.
Discount Cleaning Products is an authorized dealer with US-based customer service. Our team works with janitorial contractors, facility managers, and property-maintenance professionals every day and can help you confirm fit and compatibility before you order.
