When a Bissell upright starts leaving carpet fibers flat instead of lifted, or the brush stops spinning even with a good belt installed, the agitator itself has usually worn out. The 203-2449 is Bissell's OEM 14-1/4 inch brush roller assembly, built to restore full carpet agitation on CleanView, PowerForce, PowerGlide, and related commercial-duty uprights without replacing the whole machine. It's a common repair part for facilities and households running daily vacuum cycles, where bristle wear shows up faster than on a machine used a few times a week.
Built for these situations
- Flattened or frayed bristles that no longer dig into carpet pile, even though the vacuum still has suction.
- Brush roll not spinning after the belt has already been checked and confirmed intact.
- Strong performance on hard floor but weak pickup on carpet - a classic sign the bristles are worn below effective depth.
- Routine preventive replacement on commercial machines that see daily use, where a 6-12 month wear cycle is common.
- Replacing an obsolete Bissell brush roll - this part supersedes older part numbers 203-6729, 203-6756, 203-6726, 203-1195, and 203-2013.
Specifications
- Manufacturer: Bissell (Genuine OEM part)
- Part number: 203-2449
- Brush roller length: 14-1/4 inch
- Includes: 1 brush roller with attached end caps
- Supersedes: 203-6729, 203-6756, 203-6726, 203-1195, 203-2013
Will this brushroll fit my Bissell vacuum?
The 203-2449 fits a wide range of Bissell CleanView, CleanView II, PowerForce, PowerGlide, PowerTrak, Rewind, and Velocity upright models. Compatibility is by vacuum model number rather than by series name alone, so check your specific model number against the vacuum's rating plate before ordering. If your model isn't a match, a similar-looking part number, 203-2448, covers a different but related range of Bissell models - these two are easy to mix up.
How do I know if I need a new brushroll instead of just a new belt?
Start with the belt. If the belt is intact, properly seated, and not stretched or glazed, but the brush still won't spin freely by hand, or the bristles are visibly flattened, frayed, or worn down to less than about 1/4 inch, the brush roller itself needs to be replaced rather than the belt.
Does this brushroll come with a belt?
No. This listing is the brush roller assembly with end caps only. If your belt is worn, stretched, or broken, order a replacement belt separately along with the brushroll.
How do I replace the brushroll on my Bissell upright?
Unplug the vacuum, then remove the screws on the bottom base plate to access the brush roll compartment. Slide the belt off the motor gear, then lift the old brush roller straight out of its end mounts. Fit the new 203-2449 roller into the same mounts, reseat the belt around the motor gear and roller, and replace the base plate. Spin the roller by hand before plugging back in to confirm it turns freely.
How often should the brushroll be replaced?
For typical household use, every 6-12 months is common. Commercial or daily-use machines wear bristles faster and may need replacement more often - watch for reduced carpet pickup as the practical signal rather than relying on a fixed schedule.
Discount Cleaning Products is an authorized Bissell commercial dealer, stocking genuine OEM parts like the 203-2449 for facilities and households that depend on their vacuums running daily. Our customer service team is US-based and can help confirm fitment before you order.