Keep your Edco scarifier cutting fast and clean with these genuine 20326 carbide cutters. This is the CP308T 8-point cutter, 2-1/4 inch tungsten-carbide flail tip for Edco CPM-10 and CPU-10FC scarifiers on the 6-shaft drum. Tungsten carbide holds its edge far longer than steel, so the drum keeps removing material at full rate instead of polishing the surface as worn cutters do.
Built for
- Removing pavement markings, epoxy, paint, and waterproofing membranes
- Leveling, grooving, and milling concrete for surface prep
- Cleaning and texturing floors before coating or overlay
- Restoring cutting speed on a drum with worn or chipped cutters
Compatibility and specs
- Genuine Edco part 20326, CP308T cutter
- 8-point, 2-1/4 inch tungsten-carbide flail cutter
- Fits Edco CPM-10 and CPU-10FC scarifiers, 6-shaft configuration
- Carbide lasts up to 30x longer and cuts up to 5x faster than steel
Frequently asked questions
Which machines and shaft setup does the 20326 fit?
It is the CP308T 8-point carbide cutter for Edco CPM-10 and CPU-10FC scarifiers in the 6-shaft drum configuration. Confirm your drum is the 6-shaft version before ordering.
How many cutters do I need?
Replace cutters as a full set so the drum stays balanced and cuts evenly. Worn or missing cutters cause vibration and uneven results, so refresh the whole drum rather than a few tips.
Why choose carbide over steel cutters?
Tungsten-carbide cutters last up to 30 times longer and remove material up to 5 times faster than steel, which lowers downtime and cost per square foot on production work.
Will worn cutters damage my machine?
Running badly worn or unbalanced cutters increases vibration and bearing wear. Replacing them on schedule protects the drum and shafts and keeps cut quality consistent.
Discount Cleaning Products is here to help you order the right Edco wear parts, backed by US-based customer service. Tell us your scarifier model and shaft count and we will confirm the 20326 is the correct cutter for your drum.