The Edco 42500 (model SB-14-11H) is a 14-inch up-cut walk-behind saw built for concrete and asphalt contractors who need clean, precise cuts and reliable dust control. Powered by an 11 HP Honda gas engine, it gives crews the muscle for expansion joints, green concrete, and asphalt repairs while its up-cut blade rotation keeps the base of every cut level and the work area cleaner.
What it is best for
The up-cut design and 14-inch blade make this saw a go-to for short-run and detail cutting where a full-size flat saw is overkill.
- Expansion joint cleaning and re-cutting
- Green (fresh) concrete cutting
- Contraction joints and short-run slab cutting
- Asphalt patch repairs and trenching
- Traffic loop (detector loop) installation
Why up-cut rotation matters
Unlike a down-cut saw, the blade on the 42500 rotates against the forward direction of travel. That up-cut action lifts debris into the standard 2-inch vacuum port for dry dust collection and leaves a level, clean surface at the base of the cut - a real advantage for joint work and loop installation where finish quality counts.
Built to take a beating
A heavy-duty 7-gauge steel frame and undercarriage resist bending and dampen vibration for straighter cuts and longer service life. The saw cuts up to roughly 4-3/4 inches deep. An optional air-motor version comes fully equipped with a lubricator, moisture separator, and handle-mounted on/off valve (requires 160 CFM at 90 PSI) for use where exhaust-free operation is required.
Specifications
- Model: SB-14-11H
- Blade: 14 inch, up-cut rotation
- Engine: 11 HP Honda gas, 3600 RPM
- Max cut depth: approx. 4-3/4 inch
- Weight: approx. 200 lbs
- Frame: 7-gauge steel frame and undercarriage
- Dust control: 2-inch vacuum port (standard)
- Power options: gasoline, electric, or air motor (160 CFM at 90 PSI)
Frequently asked questions
What is the difference between an up-cut and down-cut saw?
On an up-cut saw like the 42500, the blade rotates against the direction of travel, lifting cuttings into the vacuum port for dry dust collection and leaving a level base in the cut. Down-cut saws throw debris forward and are better suited to long, deep slab cuts.
What size blade does the Edco 42500 use?
It uses a 14-inch blade and cuts to a maximum depth of about 4-3/4 inches, which suits expansion joints, contraction joints, green concrete, and asphalt patch work.
Can it be used for green concrete cutting?
Yes. The 42500 is ideal for green (fresh) concrete cutting and expansion-joint work, where the up-cut blade and rigid frame help produce clean, level joints.
Does it collect dust?
Yes. A 2-inch vacuum port is standard. Connect a compatible dust extractor or HEPA vacuum to capture silica dust for OSHA-compliant dry cutting.
Is an air-powered version available?
Yes. An optional air-motor model includes a lubricator, moisture separator, and handle-mounted on/off valve, and requires an air supply of 160 CFM at 90 PSI.
Discount Cleaning Products is an authorized Edco dealer with US-based support to help you match the right walk-behind saw and blade to your cutting application.