A hardened or split O-ring is a small part that causes big problems - leaks, lost pressure, and dust or water where it does not belong. The Edco 63016 is O-Ring number 231, sized 1/8 inch cross-section by 2-5/8 inch inside diameter, a genuine EDCO replacement seal for EDCO surface-prep equipment. Swapping a worn O-ring during service restores a clean, tight seal and keeps your machine running the way it should.
Built for
- EDCO grinders, scarifiers, saws, and surface-prep equipment that use O-ring 231
- Routine rebuilds and service where old seals have hardened, flattened, or split
- Technicians who want the correct OEM seal size rather than a guessed substitute
Why it matters
- Restores a tight seal to stop leaks and pressure loss
- Correct 1/8 by 2-5/8 inch ID sizing for a proper fit
- Genuine EDCO wear part for dependable service life
Specifications
- O-Ring number: 231
- Cross-section: 1/8 inch
- Inside diameter: 2-5/8 inch
- Part: EDCO 63016
Frequently asked questions
What size is the 63016 O-ring?
It is O-ring number 231, with a 1/8 inch cross-section and a 2-5/8 inch inside diameter.
When should I replace an O-ring?
Replace it during service if the seal has hardened, flattened, cracked, or if you see leaks or pressure loss where the O-ring seats.
Is this a genuine EDCO part?
Yes. The 63016 is a genuine EDCO replacement O-ring sized for a correct fit.
Discount Cleaning Products is an authorized EDCO dealer with US-based service and support. Keep the 63016 on hand so a worn seal never sidelines your equipment.
