The MK Diamond MK-200 10-inch tile blade is the workhorse size for a shop or jobsite wet saw, cutting ceramic, porcelain, marble and dense floor tile with a smooth, chip-free edge. It is a continuous rim wet cutting blade from MK's standard grade tile line, and part number 137166 is the 10-inch diameter on a 5/8-inch arbor.
The MK-200 is MK Diamond's standard grade continuous rim wet cutting tile blade, and the continuous rim is the reason it lands on finish work: an unbroken diamond edge leaves no segment gullets to hammer the glaze, so cuts come off the saw smooth enough to set without a second pass on a stone or a grinder. MK rates the series for tile, marble and other stone, and calls it out as an especially strong performer on dense floor materials, which is the category most likely to chip with a cheap blade.
Use Cases
- Straight and diagonal cuts in ceramic and porcelain floor and wall tile on a wet table saw
- Marble, travertine and other dimension stone where a chipped edge cannot be hidden by grout
- Dense pavers and quarry tile that dull a general purpose blade quickly
- Large-format floor tile where a longer cut length keeps the edge straight
- Remodel and punch-list work where one blade has to cover several tile bodies on the same job
Why this size
Ten inches is the most common wet tile saw size in the trade, and the extra diameter over an 8-inch blade buys depth of cut and a longer stroke through large-format tile without slowing the feed. On a 5/8-inch arbor it drops onto the majority of professional and rental-fleet wet saws with no bushing.
Specifications
- Manufacturer: MK Diamond Products
- Model: MK-200, standard grade tile blade
- MK part number: 137166
- Blade diameter: 10 in (254 mm)
- Blade width (kerf): .060 in
- Arbor: 5/8 in
- Rim type: continuous rim
- Rim height: 8 mm
- Cutting method: wet
- Materials: tile, marble, stone and dense floor materials
Frequently asked questions
What does the 8 mm rim height mean for blade life?
Rim height is the depth of usable diamond above the steel core. At 8 mm the MK-200 carries a full-height rim for its class, so there is real material to wear through before the blade reaches the core. Once the rim wears down near the core the blade is finished and should be replaced rather than pushed.
Can this blade be used dry?
No. The MK-200 is a wet cutting blade. Running a continuous rim blade dry removes the cooling and flushing that water provides, and heat is the most common cause of premature blade failure, showing up as discoloration of the steel core just under the rim. Keep a steady water supply on both sides of the blade for the whole cut.
Why is my porcelain still chipping?
Chipping on hard porcelain usually traces to feed rate, water volume or an unsupported tile edge rather than the blade itself. Slow the last inch of the cut, keep the tile flat against the table and fence, make sure water is reaching the rim and not just the tray, and cut with the finished face up on a table saw so any breakout lands on the back.
Does MK offer other arbor sizes for this blade?
MK Diamond states that special arbors are available on request, and that stock arbors can be bushed down to smaller sizes if you specify that at the time of order. Contact us before ordering if your saw needs a size other than the stock arbor listed above.
Discount Cleaning Products is an authorized MK Diamond dealer. MK Diamond Products has built cutting, coring and polishing equipment in the United States since 1868 and backs its blades through a US-based service and distributor network, so replacement segments, arbor questions and warranty claims go through people who work on these saws every day. If you are not certain which diameter or arbor matches your saw, send us the make and model and we will confirm the correct part number before you order.
