The Aztec ProScrub AGM is the machine a contractor buys when the mop bucket has stopped keeping up but a rider is not remotely justified. It is a 20-inch walk-behind auto scrubber that wet-scrubs and dry-vacuums in a single pass, covering up to 16,000 square feet per hour, and this AGM configuration ships ready to run with upgraded glass-matte batteries, the charger and a pad driver already in the box. The buyer here is typically a building service contractor, a school or church maintenance lead, or a gas station and c-store operator who needs hard floors turned around fast between openings and does not want a machine that requires a specialist to maintain.
What sets this model apart is the battery choice. Glass-matte AGM batteries are sealed and maintenance free, which removes the single most-skipped task in floor equipment ownership: watering flooded lead-acid cells. Crews forget. Batteries die early. With AGM you charge it and you run it, and the 24-volt system delivers roughly three hours of runtime on a full charge, which is enough to cover most single-shift routes without a mid-job swap.
Built for: common use cases
- Convenience stores and fuel-station interiors where tracked-in grit has to come off tile every night without closing the floor to customers for long.
- Schools, gyms and churches cleaning large stretches of hard floor on a fixed labor budget.
- Building service contractors who need one dependable mid-size scrubber that any crew member can be trained on in an afternoon.
- Warehouses and back-of-house areas where a 20-inch path fits through standard doorways and around racking that a larger machine cannot navigate.
- Operations replacing mop-and-bucket cleaning and wanting a genuine drying pass rather than a wet floor left behind.
Why crews keep choosing it
The recurring comment from operators is that the ProScrub is simple to operate and simple to maintain. That is not a small thing. In this class the machines that fail early are usually the ones with fussy controls that get bypassed and service points crews cannot reach. The ProScrub is a brush-driven design with straightforward controls, a 15-gallon recovery tank that outsizes the 12-gallon solution tank so you are not chasing overflow, and a 30-inch squeegee that pulls water wide of the scrub path for a genuinely dry finish.
The 65 pounds of scrubbing pressure is the other practical number. It is enough to lift embedded soil and old finish residue on tile and sealed concrete without gouging, which is where lighter machines leave you doing a second pass.
Specifications
- Cleaning path: 20 inches
- Productivity: up to 16,000 sq ft per hour
- Solution tank: 12 gallons
- Recovery tank: 15 gallons
- Brush motor: 3/4 HP at 220 RPM
- Vacuum motor: 1/2 HP, 24 volt
- Scrubbing pressure: 65 lbs
- Squeegee width: 30 inches
- Pad holder with red scrubbing pads included
Frequently asked questions
What is included with the AGM model?
This configuration includes the upgraded glass-matte AGM batteries, the battery charger and a pad driver with red scrubbing pads. It is the ready-to-run version of the ProScrub.
How long does it run on one charge?
The 24-volt system delivers approximately three hours of runtime from a full charge under typical scrubbing conditions.
Do the AGM batteries need watering?
No. Glass-matte AGM batteries are sealed and maintenance free, so there are no cells to check or top off. That is the main reason operators upgrade from flooded lead-acid.
What surfaces is it suited to?
It is intended for hard floors such as VCT, ceramic and quarry tile, sealed and polished concrete, and similar commercial hard surfaces.
How much floor can it actually cover?
Rated productivity is up to 16,000 square feet per hour. Real-world coverage depends on obstacles, turns and soil load, but the 20-inch path and 30-inch squeegee make it efficient in open runs.
What is the difference between this and the base ProScrub-B?
The base ProScrub-B is the same machine supplied without batteries and without a charger, for buyers who already have a 24-volt battery set or want to specify their own.
Discount Cleaning Products is an authorized dealer supplying commercial cleaning contractors, facility maintenance teams and building service crews across the United States. Our US-based staff works with this equipment every day and can help you confirm fit, sort out compatibility questions and source the rest of what your crews run through.
