A hard surface spinner tool only works if it recovers everything it puts down. The moment the vacuum hose on an SX-12 splits, collapses, or loses a cuff, the tool stops picking up and starts pushing dirty water across the floor, which is the fastest way to turn a tile and grout job into a callback. The Sandia 10-0859-I is the genuine replacement vacuum hose for that tool, and swapping it restores the seal the spinner depends on.
This is a part for tile and grout specialists, restoration crews, and building service contractors who run Sandia's 12-inch hard surface turbo brush tool on restrooms, kitchens, entryways, and locker rooms. Those are exactly the floors where a tool that leaves standing water is unacceptable, so the hose gets treated as a consumable rather than something to patch with tape.
Built for
- Restoring recovery on an SX-12 spinner tool that has started leaving water behind
- Replacing a hose that has been crushed, kinked, or split at a cuff
- Servicing a hard surface tool before a large restroom or kitchen contract
- Rebuilding a used tool purchased secondhand or pulled from long-term storage
- Stocking a spare hose so a tile and grout crew is never down mid-job
Specifications
- Manufacturer: Sandia Products
- Part number: 10-0859-I
- Category: Hard surface tool vacuum hose
- Fits: Sandia SX-12 / 10-0859 12-inch hard surface turbo brush tool
- Warranty: Sandia covers parts, tools and accessories for 90 days. Vacuum motors carry a 2-year warranty; 100 psi pumps carry 2 years and all other pumps 1 year. Sandia covers up to one year of service labor at the manufacturer rate through an authorized service center.
The Sandia warranty does not cover failures caused by improper or missing maintenance, misapplication, misuse, tampering, or substitution of supplied parts. It also excludes pumps stored in freezing conditions, pumps run dry for extended periods, use of powdered detergent, failure to flush the system regularly with a vinegar solution, filters removed from the solution tank, and inline filters that are not cleaned regularly.
Frequently asked questions
How do I know the vacuum hose is the problem?
If the spinner leaves a visible film or standing water while the machine's vacuum still sounds strong, air is being pulled in somewhere other than the floor. Check the hose for splits, soft collapsed sections, and loose or cracked cuffs before suspecting the vacuum motor.
What does the SX-12 refer to?
It is Sandia's 12-inch hard surface turbo brush tool, the spinner used for tile, grout, and other hard floors. The 10-0859-I is the vacuum hose service part for that tool.
Can I use a generic vacuum hose?
Generic hose often has the wrong inside diameter or a cuff that will not seat, and either one costs you lift at the head. The genuine part is matched to the tool's connection so the seal is correct.
How do I make a vacuum hose last longer?
Avoid dragging it around door frames and equipment corners, do not let machines roll over it, flush it after jobs that involve heavy grease or grout slurry, and hang it in loose coils rather than tight folds when you store it.
Is this hose covered by warranty?
Sandia covers parts, tools, and accessories for 90 days. Damage from crushing, abrasion, or misuse is not covered, which is why most crews treat the hose as a wear item and keep a spare.
Discount Cleaning Products is an authorized Sandia dealer, so every part on this page is a genuine Sandia component built to the same tolerances as the one that shipped with your machine. Our US-based team works with these extractors every day and can help you confirm the right part number for your serial number before you order, which is usually faster than pulling the machine apart twice. If you keep a small shelf of wear parts on hand, you spend your day cleaning instead of waiting on a repair.
