This is the 875 watt in-line heating element Sandia lists as 10-1500-C for Sniper carpet extractors. Trade listings describe it as the 875 watt heating element for the Sniper line, which places it between the 600 watt element and the 1000 watt element in the same family.
An in-line element sits between the solution pump and the spray jets and warms the cleaning solution on the way to the carpet. That matters because warm solution releases oily soil faster than cold, so the operator gets more out of each pass without filling the tank from a hot tap. Sandia's own literature for heated Sniper machines describes an in-line heater running to around 198 degrees F for maximum productivity.
Elements are wear parts. They fail from scale buildup in hard-water areas and from being run dry when the solution tank empties mid-pass. The classic symptom is a machine that still sprays normally but no longer delivers heat.
Use cases
- Restoring heat on a Sniper extractor that still sprays but runs cold
- Planned replacement in hard-water regions where scale shortens element life
- Carpet cleaning contractors who sell heated cleaning and cannot arrive cold
- Facility and restoration crews servicing their own extraction equipment
- Rebuilding a used heated Sandia machine before it returns to the schedule
Specifications
- Sandia part number 10-1500-C
- Rated 875 watts
- In-line solution heating element for Sandia Sniper carpet extractors
- Service and wear part
Matching the right element
Sandia lists several elements in the 10-1500 family, and they are not interchangeable. Trade listings identify 10-1500-A as a 1000 watt element for the 12 gallon Sniper, 10-1500-B as the element for the 6 gallon canister Sniper, and 10-1500-C as an 875 watt element. Sandia also lists 220 volt versions, including 10-1500-220 at 1000 watts and 10-1500-B-220 at 600 watts. Sandia does not publish a parts breakdown for the Sniper series, so match the element to your machine's model number and supply voltage rather than by wattage alone.
Warranty
Sandia's published warranty policy covers parts, tools and accessories for 90 days. It excludes failures caused by improper maintenance or lack of maintenance, misapplication, misuse, tampering, or substitution of provided parts.
Frequently asked questions
How do I know the element has failed?
If the pump still sprays at full pressure but the solution never warms up, the element or its thermostat and wiring are the place to look. Check continuity at the element before replacing anything else.
What kills a heating element fastest?
Scale from hard water and running the machine dry. Flushing the solution line at the end of a job and keeping an eye on the tank level are the two habits that make elements last.
Can I fit a higher wattage element than the one that came out?
Not as a substitution. Wattage has to match what the machine's wiring, thermostat and switch were built for. Match the Sandia part number and voltage to your machine.
Will a 220 volt element work on 110 volt supply?
No. Voltage has to match the machine and the supply. Sandia lists separate 220 volt versions of these elements for machines built for that supply.
Discount Cleaning Products supplies Sandia extractor parts and consumables, with US-based order support.
