Every gap in a house that collects debris is too narrow for the floor head - the track beside a car seat, the seam where a cushion meets the frame, the two inches between the refrigerator and the cabinet. The crevice tool is the attachment that reaches them, and it is also the one most likely to go missing. This is the replacement crevice tool for the Dyson DC07 upright, matching Dyson part 904083-07.
Built for
DC07 and DC14 owners replacing a lost or cracked crevice tool, and anyone who wants the single part rather than a three-piece attachment kit.
Use Cases
- Cleaning between and under couch cushions and along furniture seams
- Vacuuming car footwells, seat tracks, and console gaps
- Reaching baseboard edges, radiator fins, and heater vents
- Getting into the narrow gaps beside appliances and cabinets
Checking the fitment
The 904083-07 is the DC07 crevice tool and also fits the DC14, which shares the same attachment interface. Across the wider DC01 through DC17 range the connector is broadly common, but the safest check is the tool you are replacing - if you still have a working attachment for the machine, compare the collar before ordering rather than relying on the model list alone.
Using a crevice tool without damaging anything
The tapered tip concentrates airflow, and it also concentrates pressure onto a small edge of hard plastic. On car interiors, upholstery piping and painted baseboards, guide it rather than jamming it into the gap - the suction does the work and forcing the tip is how trim gets scuffed. If the tool blocks, and a crevice tool is the attachment most likely to block, clear it from the tip end rather than pushing the obstruction further down into the wand where it is far harder to reach.
Specifications
- Narrow tapered crevice nozzle
- Replaces Dyson part number 904083-07
- Fits Dyson DC07 upright vacuums and the DC14 generation
Frequently asked questions
Which Dyson models does 904083-07 fit?
It is the DC07 crevice tool and also fits the DC14, which shares the attachment fitment. Replacement tools in this format are commonly listed across the DC07 and DC14 generation.
What is the difference between the crevice tool and the upholstery tool?
The crevice tool is narrow and tapered for reaching into gaps; the upholstery tool is wide and flat for covering fabric surfaces. They are not interchangeable - most people end up wanting both.
Why does suction feel stronger through the crevice tool?
Airflow is concentrated through a much smaller opening, so air speed at the tip goes up. That is what lets it pull debris out of a gap the floor head just passes over.
Can I buy this without the whole attachment kit?
Yes, that is the point of this listing. If the crevice tool is the only piece you lost, there is no reason to buy a kit to replace it.
Discount Cleaning Products is an authorized dealer for the brands we carry, with US-based support from people who work with commercial cleaning equipment every day. If you are not certain this part matches your machine, send us the model and serial number and we will confirm the fit before you order.
