Anyone who has run an EDCO floor grinder knows the failure mode: the machine is on site, the slab is ready, and the wedges or the punch are back at the shop in the bottom of a bucket. This is the empty black tool box EDCO supplies for that problem. It is the case that holds Dyma-Serts and the small change tooling that goes with them, sold on its own so you can organize the accessories you already have or replace a box that has gone missing.
Built for
- Concrete contractors running EDCO Magna-Trap grinders between jobsites
- Rental yards that need a machine's tooling to come back complete
- Replacing a cracked, lost or left-behind accessory case
- Separating diamond tooling from carbide tooling so crews grab the right one
- Crews adding a second set of tooling and needing somewhere to keep it
Why EDCO colour codes the boxes
EDCO runs two families of tooling on the same multi-accessory disc, and they behave very differently. Dyma-Serts are diamond segments welded to a backing plate, used to grind and to take off tough coatings. Strip-Serts are carbide-tipped blocks meant to strip a floor clean without cutting into the concrete. Put the wrong one on a slab and you either fail to remove the coating or you gouge a floor that was only supposed to be cleaned. The black box carries the Dyma-Serts and the red box carries the Strip-Serts, which is a small thing that stops a large mistake when a crew is loading out at six in the morning.
Specifications
- EDCO part number 12001
- Tool box, black, listed by EDCO for Dyma-Serts
- Supplied empty; tooling, hammer and punch are not included
- Accessory for EDCO floor grinders
Frequently asked questions
Does this box come with any tooling?
No. The 12001 is supplied empty. If you want a box that arrives with the change tooling in it, EDCO's 12004 black box includes a hammer and punch.
What is the difference between the black box and the red box?
EDCO lists the black 12001 for Dyma-Serts, the diamond tooling, and the red 12002 for Strip-Serts, the carbide tooling. Keeping the two separated by colour is how crews avoid putting the wrong tooling on a slab.
Will Dyma-Serts from other machines fit in it?
The box is sized for EDCO's own Dyma-Sert tooling and the wedges that go with it. It is a storage case rather than a fitted insert, so it is generally used for whatever EDCO accessories a crew carries.
Is this the same box the grinder ships with?
It is the EDCO accessory box, part 12001, sold separately. Contractors most often buy it as a replacement or to organize a second set of tooling.
Do I need the hammer and punch as well?
You need them to change tooling. The punch drives the wedges that hold Dyma-Serts and Strip-Serts on the multi-accessory disc, and the hammer strikes the punch. EDCO sells both, individually and as part of the 12004 box.
Discount Cleaning Products supplies EDCO surface prep equipment, tooling and accessories, with US-based order support for contractors and rental fleets.
