Crushproof Vacuum Hose, 50 ft. x 1-1/2 in. (MF# 15F50W0)
When a vacuum hose fails on a car wash island or a restoration job, it almost never fails at the machine. It fails in the middle of the run, where the hose gets stepped on, dragged over concrete and, sooner or later, driven over. This 50-foot crushproof hose is the answer to that problem: a heavy, flexible 1-1/2 inch line built so the wall springs back instead of staying flattened.
The practical benefit is reach. Fifty feet lets one operator cover a whole vacuum island, a full detail bay or a long corridor without stopping to reposition the machine. For crews paid by the job rather than the hour, that is time that goes straight back into the day.
Built for
- Car wash and detail vacuum islands where the hose lies on the ground and takes tire traffic daily.
- Wet/dry and flood recovery work where hoses get dragged through doorways and around furniture.
- Shop and warehouse cleanup with a central or portable vacuum parked away from the work.
- Replacing a split or collapsed hose on a machine that is otherwise still in good shape.
Why the diameter matters
1-1/2 inch is the workhorse size in commercial vacuum work. It moves enough volume to pick up wet debris, grit and litter, while staying light enough that an operator can handle 50 feet of it one-handed. It is also the most widely stocked size, so cuffs, wands, crevice tools and floor tools are easy to source and easy to swap between machines.
Specifications
- Length: 50 feet
- Inside diameter: 1-1/2 inches
- Construction: crushproof
- Color: gray
- Manufacturer part number: 15F50W0
Frequently asked questions
What does crushproof actually mean on a vacuum hose?
It refers to the wall construction. A crushproof hose is built so that when weight comes off it, the hose returns to its round shape and airflow returns with it. A standard hose that gets driven over or pinched under a wheel can stay flattened and choke suction permanently.
What size fittings does this hose take?
It is a 1-1/2 inch inside diameter hose, which is the standard commercial vacuum size. Cuffs, wands and floor tools in 1-1/2 inch are widely available. If you are matching an existing machine, measure the inside diameter of the hose you are replacing rather than the outside.
Can I cut this hose to a shorter length?
Yes. Many shops buy the 50-foot length and cut it down to build two shorter runs or to replace a damaged section. Cut between the ribs with a sharp blade and fit a cuff to the new end.
Will a longer hose reduce my suction?
Every additional foot of hose adds some airflow resistance, so a 50-foot run will not pull quite as hard at the tool as a 15-foot run on the same machine. In practice the trade is usually worth it, because the alternative is moving the vacuum repeatedly. If you need maximum lift for a specific task, use the shortest hose that reaches.
Is this hose suitable for wet pickup?
It is commonly used on wet/dry vacuums and car wash vacuums, both of which routinely pick up water. Check that your machine is rated for wet recovery before using it that way.
Discount Cleaning Products is an authorized dealer for the commercial cleaning brands we carry, with US-based support from people who work with this equipment every day. If you are unsure which part or configuration fits your machine, send us your model and serial number and we will confirm the correct item before you order.
