Horse hair is chosen for one reason: it is soft enough to sweep a finished floor without scuffing it. Terrazzo, sealed hardwood, polished concrete, VCT with a fresh coat of finish and stone lobbies all get vacuumed nightly, and the brush that touches them is the part most likely to leave a mark if it is wrong or worn. The Sandia 10-0441-A is the factory replacement brush for the Sandia 10-0441 14-inch horse hair floor brush, listed by Sandia in exactly those terms.
Bristles wear in two ways that matter. They shorten, so the head starts riding on its housing instead of the brush, and they stiffen and splay as the tips break down, which is when a soft brush stops behaving like a soft brush. Neither shows up as a broken tool - both show up on the floor. Replacing the brush strip on a schedule is far cheaper than refinishing a lobby.
Built for
- Polished stone and terrazzo lobbies - soft bristles sweep fine grit without marking the finish
- Sealed hardwood and gym floors - horse hair is the standard choice where finish protection matters
- Freshly finished VCT - a worn or stiff brush is what puts swirl marks in new coats
- Museums, showrooms and executive floors - visible surfaces with no tolerance for scratching
- Any crew already running the 10-0441 - this is the wear part that keeps it doing its job
Use cases
Most facilities replace the brush when the bristle length drops noticeably against a new one, or at a fixed annual interval on high-traffic entrance and lobby routes. Crews that maintain finished floors tend to do it early rather than late, because the cost of the brush is trivial next to the cost of a burnishing or refinishing cycle brought forward.
Specifications
- Sandia part number: 10-0441-A
- Type: replacement horse hair brush
- Fits: Sandia 10-0441 14 in. Horse Hair Floor Brush
- Bristle: horse hair, soft, for finished and polished floors
- Listed by Sandia under Raven 6-Quart and Raven 10-Quart Backpack Vacuum accessories
Frequently asked questions
What tool does the 10-0441-A fit?
Sandia lists it as the replacement brush for the 14 in. Horse Hair Brush, part number 10-0441. It is not the replacement for the nylon brush tool, which uses 10-0183-A.
Why horse hair instead of nylon?
Horse hair is soft enough to sweep polished and sealed floors without scuffing the finish. Nylon is stiffer and better suited to textured or industrial surfaces where marking is not a concern.
When should the brush be replaced?
When the bristles have shortened noticeably against a new strip, or when the tips have splayed. Both mean the head is no longer sweeping the way it did when it was new.
Will a worn brush damage a finished floor?
A worn or splayed brush lets the tool housing ride closer to the surface and drags grit rather than sweeping it, which is how witness marks start. Replacing the strip on a schedule avoids the question.
Is this the genuine Sandia part?
Yes. Factory Sandia 10-0441-A.
Discount Cleaning Products is an authorized Sandia dealer. Every Sandia part we list is genuine factory stock, and our US-based team can confirm fitment against your machine's model and serial number before you order, so a service part arrives ready to install instead of sitting on the shelf as the wrong number.
