This is the green carbon brush Sandia lists as 10-1333-G for the 2-stage Sniper vacuum motor. Two-stage motors do the heavy lifting on portable extractors, and they are the first thing an operator notices when brushes go short: recovery slows, the machine sounds harsher, and water starts coming back in the hose rather than the tank.
Brushes are the sacrificial carbon blocks that carry current to the spinning armature. They shorten steadily with running hours, and once they get too short the motor loses power, sparks at the brush ports, and eventually stops. Published maintenance guidance for extractor vacuum motors puts brush replacement in the region of 1,000 to 1,200 running hours, and central vacuum parts suppliers advise replacing a brush once it has worn down to roughly 3/16 inch. Running past that point risks scoring the commutator, which turns a low-cost brush change into a motor replacement.
Use cases
- Scheduled service on a Sniper extractor with a 2-stage vacuum motor
- Recovering suction on a machine that leaves carpet wetter than it used to
- Truck and van stock for cleaning contractors working away from the shop
- In-house maintenance on facility-owned Sandia extractors
- Refitting a used 2-stage motor before returning a machine to service
Specifications
- Sandia part number 10-1333-G
- Green brush, listed by Sandia for the 2-stage Sniper motor
- Carbon motor brush for a vacuum motor
- Consumable wear part, replaced on a maintenance interval
Matching the right brush
Sandia lists this brush family in several variants, separated by color and by motor: 10-1333 black, 10-1333-C cream for the XP-3, 10-1333-G green for the 2-stage Sniper motor, and 10-1333-O orange for the XP-3. Sandia does not publish an interchange chart, so match the brush to the motor actually fitted to your machine and to the color of the brush you are removing, rather than by machine model alone. Vacuum motors get replaced over a machine's working life, so what a machine shipped with is not always what is in it today.
Warranty
Sandia's published warranty policy covers parts, tools and accessories for 90 days. It excludes failures caused by improper maintenance or lack of maintenance, misapplication, misuse, tampering, or substitution of provided parts.
Frequently asked questions
How many brushes does a vacuum motor use?
A vacuum motor carries two brushes, one at each side of the motor tube. Replace them as a pair so they wear evenly, and check the packaged quantity against what your motor needs.
How do I know my brushes are worn?
The usual signs are falling suction, visible sparking at the brush caps and a motor that cuts out under load. Removing the brush cap with a flat screwdriver lets you measure the carbon that is left.
How often should motor brushes be changed?
Published guidance for extractor vacuum motors is roughly 1,000 to 1,200 running hours, but duty cycle decides it. Inspect on a schedule and replace at about 3/16 inch of remaining carbon.
Can the wrong brush damage the motor?
A brush that does not match the motor can seat badly and wear the commutator. Match the color and the Sandia part number to the brush you removed.
Discount Cleaning Products supplies Sandia extractor parts and consumables, with US-based order support.
