On an EDCO CPM-8 Crete-Planer, the rear wheel spacers are one of the small parts that decide whether the machine cuts flat. They set the rear wheel position, which in turn sets how the drum sits against the slab - and a worn, lost, or mismatched spacer shows up immediately as an uneven cut, chatter, or a machine that will not hold depth across a pass. The 65005 is the genuine EDCO 2-1/8 in. rear wheel spacer, listed in the CPM-8 parts manual under the rear fork and control linkage grouping. This listing is the spacer only.
Built for
Concrete contractors, surface prep crews, and rental yards maintaining an EDCO CPM-8 8 in. walk-behind scarifier who need the correct rear wheel spacer for a rebuild, a wheel change, or to replace a spacer that walked off on a job.
Use cases
- Rear wheel service - replacing spacers when repacking or swapping rear wheels on a CPM-8.
- Restoring cut quality - correcting uneven depth or chatter traced to a missing or worn spacer.
- Rental fleet maintenance - keeping spare spacers on the shelf so a machine is not down over a small part.
- Rear fork and control linkage rebuilds where the spacer stack has to be reassembled to factory dimensions.
Specifications
- Part: rear wheel spacer
- Size: 2-1/8 in.
- Fits: EDCO CPM-8 8 in. walk-behind Crete-Planer scarifier
- Parts manual group: rear fork and control linkage
- Configuration: spacer only - wheel and hardware not included
- Manufacturer part number: 65005
About the CPM-8 scarifier this part fits
- 8 in. working width; scarifies approximately 350 to 500 sq. ft. per hour at 1/8 in. depth per pass
- Removes traffic lines at roughly 800 to 1,000 lineal ft. per hour
- Power source mounted over the drum to reduce vibration and maximize surface contact
- Vacuum port equipped, with a standard water misting system
- Optional edger attachment reaches within 1-3/4 in. of a vertical surface
- Electric model: 5 HP, 230 V single phase, 19.5 amps, 2,130 RPM, 220 lbs.
Frequently asked questions
Will this spacer fit any EDCO scarifier?
It is listed as the rear wheel spacer for the CPM-8 8 in. walk-behind Crete-Planer. EDCO builds several scarifier models and the spacer stacks differ between them, so check your machine model and serial number against the parts list before ordering. We can help confirm the fit if you send us the serial number.
How do I know a rear wheel spacer is the problem?
Typical symptoms are an uneven or stepped cut across the drum width, unexpected chatter, or a machine that will not hold a consistent depth. Before ordering parts, also rule out worn or unevenly stacked cutters, since those produce a similar result.
Is this a genuine EDCO part?
Yes. Part number 65005 is the EDCO factory rear wheel spacer as documented in the CPM-8 parts listing.
Does the spacer come with the wheel or mounting hardware?
No. This listing is the spacer only. Rear wheels, axles, and fasteners are separate part numbers.
How many spacers does a CPM-8 use?
Quantity depends on your machine configuration and the spacer stack called out in your serial range parts list. Check the rear fork and control linkage group in the manual for your unit, or contact us with the serial number and we will confirm the count.
Discount Cleaning Products is an authorized dealer. Orders ship from the manufacturer or our supply network with US-based product support, and our team can help you confirm fit, compatibility, and the right accessories before you buy.
