A pre-spray is where a carpet cleaning job is won or lost, and it is also where the chemical budget goes. HydraMaster FastBreak is an ultra concentrate that dilutes 32:1 for normal work and as far as 64:1 on lightly soiled carpet, so a five gallon bucket covers a lot of route work. Owner-operators and commercial cleaning crews use it as their everyday traffic lane cleaner on nylon and olefin, where greasy soil in the walkways is the whole problem.
The formula is a blend of solvents, surfactants, and alkaline builders working together. The solvents and surfactants break surface tension so the rinse agent can reach soil down in the yarn instead of skating over it. The builders soften water, neutralize acid soiling, deflocculate ground-in soil, and sequester mineral deposits, which is why FastBreak performs consistently on hard water that flattens weaker pre-sprays. Stabilizing additives hold the concentrated solids in suspension in the bucket, and thickening agents let the formula carry roughly 30 percent more active ingredients than typical pre-sprays. Ready-to-use pH is 9.5, high enough to cut grease and low enough to be used on all synthetic fibers, including commercial wool when used as directed.
Built for these jobs
- Commercial traffic lanes – Built for the greasy, ground-in soil in corridors, entries, and cubicle walkways.
- Residential pre-spray – At 1:32 it handles normal household soil; at 1:64 it stretches across lightly soiled rooms.
- Nylon and olefin carpet – Particularly effective on both fiber types, which covers most commercial and residential installs.
- Hard water areas – Builders sequester minerals so cleaning performance does not fall off with the local water.
- High-volume route work – Ultra concentration and a 5 gallon package keep cost per job down for crews running daily.
Specifications
- Dilution range: 32:1 standard, up to 64:1 on light soil
- Ready-to-use pH: 9.5
- Package size: 5 gallon bucket
- Fiber suitability: All synthetic fibers; commercial wool when used as directed
- Application: Pump-up or inline sprayer after thorough vacuuming
Frequently asked questions
What dilution should I use?
The standard rate is 1:32 for normal to heavy traffic lane soil. On lightly soiled carpet many cleaners go to 1:64 and still get good results. Start at the standard rate on an unfamiliar account and adjust from there.
Can I use FastBreak on wool?
It can be used on commercial wool carpet when used as directed, and it is safe on all synthetic fibers. Its ready-to-use pH of 9.5 is on the safer end for a pre-spray, but always test an inconspicuous area on wool and follow the label.
How is it applied?
Vacuum the carpet thoroughly first, then dilute into a pump-up or inline sprayer and apply to the traffic lane areas. Allow the recommended dwell before extraction.
What is the difference between FastBreak and FastBreak HD?
FastBreak is the standard ultra concentrated pre-spray. FastBreak HD is the heavy duty version formulated for the worst grease and traffic lane soil. Most crews carry the standard product for routine work and the HD for problem accounts.
Why does pH matter in a pre-spray?
Higher pH cuts grease more aggressively but carries more risk to dyes and natural fibers. At a ready-to-use pH of 9.5 FastBreak is formulated to break down oily soil while staying within a range appropriate for synthetics and, used as directed, commercial wool.
Discount Cleaning Products is an authorized dealer for this line, with US-based support from people who use and service this equipment. If you are not sure this is the right item for your application, contact us before you order and we will help you match it to the job.
