The Hydro-Tek CHA1002GN is a gray non-marking pressure-washer hose, 3/8-inch by 100 feet, rated to 6,000 PSI, built for pressure-washing pros and equipment owners who work on finished surfaces where a black hose would leave scuff marks. The two-wire braid R2 construction handles high pressure and hot water, and the non-marking gray cover protects concrete, storefronts and painted surfaces while you work.
Built for
- Hot-water pressure washing on concrete, storefronts and finished surfaces
- Fleet washing, flatwork and building exteriors where marks are unacceptable
- Extending reach with a full 100-foot run on the gun side
- Replacing a worn or marking hose on a commercial pressure washer
Specifications
- Hose: 3/8-inch ID x 100 feet
- Maximum pressure: 6,000 PSI, R2 two-wire braid rating
- Maximum fluid temperature: 212 degrees F (hot-water rated)
- Ends: 3/8-inch MPT (one solid and one swivel)
- Cover: non-marking gray to protect finished surfaces
Frequently asked questions
What makes this hose non-marking?
The gray cover will not leave black scuff marks on concrete, storefronts or painted surfaces, unlike standard black hose.
What pressure and temperature can it handle?
It is rated to 6,000 PSI with an R2 two-wire braid and handles hot water up to 212 degrees F.
What are the hose ends?
It uses 3/8-inch MPT fittings, with one solid end and one swivel end to reduce kinking and twisting during use.
How long is the hose?
It is a full 100-foot length with a 3/8-inch inside diameter, adding reach for large jobs.
Discount Cleaning Products is an authorized Hydro-Tek dealer with US-based support, so you get the correct non-marking high-pressure hose for demanding commercial washing.
