The MK Diamond MK-7501 is a Pro Series blade for cured concrete with hard aggregate and non-abrasive sand, and this listing (part number 153190) is the 20-inch size, .125 inch wide with a 1-inch arbor. It belongs to the MK-Pro Series engineered for high horsepower flat saws and uses laser-welded segments, so it suits road, slab and bridge-deck crews who cut cured concrete day in and day out.
Built for
- Cutting expansion and relief joints in cured concrete slabs
- Sawing cured concrete with hard aggregate on a flat saw
- Road, parking lot and flatwork repair crews
- Rental and contractor fleets that stock a dependable cured-concrete blade
Target buyer: Concrete sawing contractors, paving and flatwork crews, and equipment fleets running high horsepower flat saws.
About MK-Pro series concrete blades
The MK-Pro Series is designed and engineered for use on high horsepower flat saws. Segments are laser welded to the steel core for strength under heavy feed pressure, and each model is tuned to a different material so the bond wears at the right rate for the aggregate you are cutting.
Choosing the right blade for the material matters more than almost anything else on a flat saw. A bond that is too hard for the material glazes and cuts slowly, and one that is too soft wears away fast. Match the model to your slab, use only the water and feed rate your saw manufacturer recommends, check the arbor and maximum RPM, and wear eye, hearing and respiratory protection.
Why it works on the job
Matched to cured concrete. MK Diamond specifies the MK-7501 for cured concrete with hard aggregate and non-abrasive sand, which helps the bond release fresh diamond at the right rate.
Flat saw ready. Part of the Pro Series designed for high horsepower flat saws, with laser-welded segments.
Tall segments. A 12mm segment height gives extra working depth before replacement.
Specifications
- Manufacturer: MK Diamond Products
- Model: MK-7501
- Part number: 153190
- Blade diameter: 20 in
- Grade: Pro Series
- Blade width: .125 in
- Segment height: 12 mm
- Construction: laser welded
- Arbor: 1 in
- Use: cured concrete with hard aggregate and non-abrasive sand on high horsepower flat saws
- Sizes in this line: 12 to 42 in
Frequently asked questions
What does the MK-7501 cut?
MK Diamond lists it for cured concrete with hard aggregate and non-abrasive sand.
What saws is it for?
It is designed for use on high horsepower flat saws.
What size is part number 153190?
This listing is the 20-inch blade at .125 inch wide with a 1-inch arbor. The MK-7501 line runs from 12 to 42 inches.
Is vertical insert undercut protection available?
MK Diamond says it is available on special order request.
Discount Cleaning Products is an authorized MK Diamond dealer with US-based customer service. If you are not sure which blade fits your saw, contact our team with the saw make and model and the material you cut, and we will help you match the right diameter, arbor and grade.
