The Sandia 10-0814 Heater Sensor is the genuine OEM temperature sensor that tells a Sandia Sniper extractor's heater when to switch on and off. It reads solution temperature in real time so the heating element holds a consistent output temperature instead of overheating. When hot-water performance gets erratic or the heater stops regulating, a failed sensor is a common and inexpensive cause.
Use cases
- Restoring consistent hot-water output on a Sandia Sniper extractor
- Replacing a heater that runs too hot, too cold, or cycles erratically
- Servicing the heat system on a 6-gallon canister Sniper
- Preventive replacement during a heater assembly rebuild
Specifications
- Genuine Sandia OEM part number 10-0814
- Automatic temperature sensor for the extractor heater
- Works with the heating element to regulate water temperature
- Built for high-temperature extractor service
Frequently asked questions
What does the 10-0814 sensor do?
It monitors solution temperature and signals the heater to turn on and off, keeping output temperature consistent and helping prevent overheating.
Which machine is it for?
It is the automatic sensor used with the heater on the Sandia Sniper 6-gallon canister extractor. Confirm your model if you are unsure.
What are the signs of a bad heater sensor?
Water that is too hot, never gets hot, or a heater that no longer cycles properly can all point to a failed temperature sensor.
Is this a genuine Sandia part?
Yes. This is the genuine Sandia OEM 10-0814 heater sensor.
Discount Cleaning Products is an authorized Sandia dealer, and our US-based team can help confirm the right part for your machine before you order.
