The Sandia 80-0007-D is the replacement spray tip for the No. 3 jet on the 12-gallon Sniper carpet extractor wand (Sandia 10-0861), rated for machines running 200 PSI and above. Jet tips are the wear item of any extractor wand: as the orifice erodes, the spray pattern turns from a crisp fan into a heavy stream, leaving carpets over-wetted in stripes and under-cleaned between passes. Swapping in a fresh tip restores the factory spray pattern in minutes.
Use Cases
Carpet cleaning contractors running Sandia Sniper 12-gallon extractors at 200, 300, or 500 PSI replace wand tips on a schedule - typically once or twice a season under daily use - to keep chemical distribution even. It is also the first part to check when a wand starts leaving streaks: a worn or partially clogged tip shows up as uneven wetting long before pump or regulator problems do. Restoration crews keep spares because hard-water scale can close a tip down mid-job.
Specifications
- Fits the No. 3 jet on Sandia 10-0861 dual-jet S-bend 12-gallon Sniper wand
- For extractors operating at 200 PSI and above
- Genuine Sandia replacement part
Frequently Asked Questions
Which wand does the 80-0007-D tip fit?
It fits the No. 3 jet position on the Sandia 10-0861 stainless steel dual-jet S-bend wand used with 12-gallon Sniper carpet extractors, on machines running 200 PSI or higher.
How do I know when to replace an extractor wand tip?
Watch the spray pattern. A healthy tip throws an even fan; a worn tip streams, stripes, or dribbles. If carpets dry unevenly or you see wet streaks after a pass, replace the tip before blaming the pump.
Can I clean a clogged tip instead of replacing it?
Light debris can be back-flushed or soaked in descaler, but once the orifice itself is worn oval the pattern never comes back. Tips are inexpensive wear parts; most contractors just replace them.
Does this work on lower-pressure Sniper extractors?
This tip is specified for 200 PSI and above. For 100 PSI machines, use the tip Sandia specifies for that pressure range so the flow rate matches the pump.
Discount Cleaning Products is an authorized dealer for this manufacturer, backed by US-based customer service. If you need help confirming fit for your equipment before you order, our team can verify compatibility by model and serial number.