Sandia Sniper 80-2100-H 12 Gallon Carpet Extractor with Heat & Hose/Wand Kit, 100 PSI Dual 2-Stage Vacuum

Sandia Sniper 80-2100-H 12 gallon heated walk-behind carpet extractor with dual 2-stage vacuum motors, 100 PSI solution pump, and stair-climbing wheels.
 
Alternative Views:


📊 AI MARKET SNAPSHOT
Best For: Cleaning crews and facilities - hotels, schools, churches, offices and restoration teams - extracting carpet over large areas with fewer tank stops.
Highlight: The Sandia Sniper 80-2100-H pairs a 12-gallon capacity with a 100 PSI pump, in-line heat and dual 2-stage vacuum fans for deep extraction and faster dry times.
Expert Note: Heated solution at 100 PSI is driven through the carpet fiber while the dual 2-stage vacuums pull the slurry back out; the 12-gallon tanks reduce trips back to the sink on big jobs.
Sale Price: $2,116.00
Estimated Shipping Cost: Free Shipping Item


Free Shipping
Product Code: T-80-2100-H


Add Upholstery Tool:


Quantity:
Description Reviews FAQ
 

The Sandia Sniper 80-2100-H is a 12-gallon walk-behind extractor built for hotels, schools, churches, office complexes, and restoration crews who need to clean a lot of square footage between refills - and need the cleaning to actually look like a deep clean, not a wet pass. The big differences between the Sniper and a smaller spot extractor: the 100 PSI pump that pushes solution all the way through the fiber, the dual 2-stage vacuums that pull the slurry back out fast enough that the carpet dries the same day, and the 2,000-watt in-line heater that turns ordinary solution into truly hot rinse water at the wand.

Why 12 gallons. A typical hotel hallway holds about 200 sq-ft of carpet between the elevators and the first guest room. With a 3-gallon spot machine an operator refills every two rooms; with the 12-gallon Sniper that is most of a wing in one fill. Less time pushing the machine to a sink, more time on the wand. For restoration jobs where the crew is rinsing dirty extraction water, the Quick-Dump 4-inch drain on the 80-2100-H pours out a 12-gallon recovery in seconds compared with the 60-90 seconds it takes to siphon a stuffed 3-gallon tank.

Specifications

  • Solution tank: 12 gallons, Easy-Fill design with garden-hose fitting
  • Recovery tank: 12 gallons, Quick-Dump 4-inch drain
  • Solution pump: 100 PSI, demand-style
  • Vacuum: dual 2-stage motors, 14.5 amp combined draw
  • Heater: 2,000-watt in-line, raises temp to ~210 deg F at the wand
  • Power cords: dual 25-ft cords (one per circuit) - use two separate 15A circuits
  • Wheels: 10-inch non-marking, stair-climbing
  • Tools included: 25-ft solution hose, 25-ft vacuum hose, stainless-steel hand wand with valve
  • Country of origin: United States

Where the 80-2100-H earns its keep

  • Hotels and dorm housing. Hallways, guest rooms, and lobbies cleaned in fewer fills, with hot extraction that lifts grease and food soils.
  • Office buildings. Cubicles and conference-room carpet that has been encap-only cleaned for years; the 100 PSI rinse cuts the buildup that maintenance encap cannot.
  • Schools and gyms. Wide carpeted assembly areas; large recovery tank handles the soil load from foot-traffic carpet.
  • Water-damage restoration. Dual 2-stage vacuums and the 4-inch dump drain make restoration extractions practical with one machine.

Frequently asked questions

Why two 25-ft cords on different circuits?

The dual vacuums plus the 2,000W heater plus the pump pull more amps than a single 15A circuit can carry. Plugging both cords into the same outlet trips the breaker. Two separate circuits is a building-electrical question for the maintenance team and is one of the things to check before booking the first job.

How does heat actually help?

Hot water cuts grease, oily foot-traffic soil, and protein-based stains that cold rinse just spreads. With a 2,000W heater the wand is putting down water at roughly 200-210 deg F - hot enough to dissolve old soil films that cold extraction barely touches. Heat also accelerates dry time because warm carpet evaporates faster.

Will it climb stairs?

The 10-inch wheels and pad-handle frame let one operator walk the empty machine up a flight of stairs. Loaded with 12 gallons it should be drained at the top of the run, not climbed full.

How long does a fill last?

Roughly 30-45 minutes of continuous wand work on a 12-gallon tank, depending on operator pace and trigger discipline. On a soiled carpet you will pull the recovery tank before you empty the solution side.

What pad/tool can I add later?

The Sniper accepts standard wand connections so a 12-inch carpet wand, a stair tool, or a tile/grout pad can swap onto the same hose set. Most operators run the included hand wand for upholstery and detail work and add a 12-inch carpet wand for production runs.

Why order the Sandia Sniper 80-2100-H from Discount Cleaning Products

Free freight shipping in the lower 48, fully assembled and tested, and a direct service relationship with Sandia for warranty parts. We have sold this exact model into hotel chains and restoration firms for years and we are happy to talk through pad-handle frame size, freight delivery options, and add-on wand selection before you order.

Features
  • 12-gallon solution and 12-gallon recovery tanks - cover ~6,000 sq-ft per fill in commercial carpet
  • 100 PSI demand-style solution pump for fiber-bottom rinsing on encap or restorative passes
  • Dual 2-stage vacuum motors deliver high water lift and faster carpet dry time
  • 2,000-watt in-line heater raises solution to ~210 deg F at the wand
  • Easy-Fill solution tank with garden-hose fitting; Quick-Dump recovery tank with 4-inch drain
  • 10-inch non-marking stair-climbing wheels and pad-handle frame
  • Includes 25-ft solution hose, 25-ft vacuum hose, and stainless-steel hand wand

Other People Purchased
Sandia 25 Ft Solution Hose Assembly with 1/4 in. Female and Male Quick Disconnects for Sandia Sniper 12 Gallon Carpet Extractor #80-0502. Sandia Stainless Steel 4" Wide Upholstery Tool, (Required for Machines with Heat), 10-0501 Vacuum Hose Assembly for Sandia Sniper 12 Gallon Carpet Extractor 80-0503
Sale Price: $98.80

Add
Sale Price: $128.56

Add
Sale Price: $65.00

Add
Sandia 80-0502 25-foot carpet extractor solution hose with quarter-inch quick disconnects Sandia 10-0501 4-inch stainless steel upholstery cleaning tool for heated spot and carpet extractors Sandia 80-0503 25-foot 1.5-inch vacuum hose assembly with cuffs for Sniper 12-gallon carpet extractor



MK Diamond MK-Black Turbo 3-1/2" (89mm) Supreme Grade Core Bit, Coring Drilling # 158715 $158.99
MK Diamond MK-Black Turbo 2-1/4" (57mm) Supreme Grade Core Bit, Coring Drilling # 158712 $104.99
Hydro-Tek HOT-2-GO Hot Water Pressure Washer 4000 @ 4.8 Gas Powered Diesel Heated $7,288.70
Lamb Ametek Brushed Blower Motor, 120 volts, 1 Stage, 5.7" Vacuum Motor Size #122341-07 $78.00
PWP HYBRID 26 FOOT WATER FED POLE, 272-20-144-PWP $389.50
EDCO 120-Grit-Double Dyma-Dot (Medium Concrete) QC2B-MC-00120 $105.00
Tucker 18" Hybrid brush with 4 Pencil Jets, 18HY-EURO-PP-XL $216.83
Tucker 18" Hybrid brush with 4 fan Jets, T-18HY-Euro-FF-XL $196.37