The Tucker DI Tank 1 Cubic Foot Complete Kit (T-DI-Tank-935) is a high-flow deionization system for professional window and solar-panel cleaners who want spot-free, pure-water results without slowing down. Built for water-fed-pole crews, exterior cleaning contractors and solar maintenance teams, it purifies ordinary tap water so glass dries crystal clear with no towel drying and no mineral spotting.
This is a complete kit, not just a tank and resin. Hook your tap-water supply hose to the 3/4-inch brass inlet and run your pure-water line off the outlet. As tap water flows through the included Tucker virgin DI resin, calcium, magnesium, chloride and other dissolved minerals are stripped out, leaving ultra-pure water that rinses away clean.
Built for
- Low-TDS areas where the cost of pure-water purification is already low and a DI tank alone is the most economical setup
- High-TDS areas when paired with a Tucker reverse osmosis system for high-volume production and long resin life
- Window cleaning, solar-panel cleaning and other jobs that demand fast, spot-free rinsing at high gallons-per-minute
The advantage of a large 1 cubic foot tank is flow: you can push many gallons per minute through it and still draw ultra-pure water, where smaller DI cartridges must run slowly to reach the same purity. At about 100 ppm incoming TDS, a fresh charge of virgin resin yields an estimated 1,600 gallons before recharging.
What is included
- 1 cubic foot DI tank
- 1 cubic foot of Tucker virgin DI resin in a reusable bucket
- 3/4-inch female swivel brass garden-hose inlet fitting
- 3/4-inch male brass garden-hose outlet fitting
- Large-mouth funnel for filling the tank
- Tucker handheld TDS meter for checking water purity
- Roll of Teflon tape for brass-fitting installation
Specifications
- Resin capacity: 1 cubic foot
- Resin type: Tucker virgin DI resin
- Inlet/outlet: 3/4-inch brass garden-hose fittings
- Estimated output: ~1,600 gallons per change at ~100 ppm incoming TDS
Frequently asked questions
How many gallons does the Tucker 1 cubic foot DI tank produce per resin change?
Output depends on incoming water quality. At roughly 100 ppm TDS, a 1 cubic foot tank of virgin resin produces an estimated 1,600 gallons of pure water before it needs recharging. Lower incoming TDS yields more gallons; higher TDS yields fewer.
Do I need a reverse osmosis system to use this DI tank?
Not in low-TDS areas. On its own, the tank produces spot-free pure water economically where source water is already low in dissolved solids. In high-TDS areas, pair it with a Tucker reverse osmosis system so the resin lasts far longer and high-volume production stays affordable.
Why is a large 1 cubic foot tank better than a small DI system?
A larger resin bed lets you run many gallons per minute and still get ultra-pure water. Smaller DI cartridges must run at much lower flow rates to reach the same purity, which slows down window and solar-panel cleaning on big jobs.
What comes in the complete kit?
Everything needed to start producing pure water: the 1 cubic foot tank, a full charge of Tucker virgin DI resin in a reusable bucket, brass garden-hose inlet and outlet fittings, a large-mouth fill funnel, a Tucker handheld TDS meter, and a roll of Teflon tape for the fittings.
Is the resin virgin or regenerated?
The kit ships with Tucker virgin DI resin, which has never been used or reprocessed. Virgin resin gives the highest, most consistent purity and longer service life than regenerated resin.
Discount Cleaning Products is an authorized Tucker dealer. The T-DI-Tank-935 ships as a complete, ready-to-run kit backed by US-based customer service that can help you size resin and fittings for your water conditions.
