If your Eureka Mighty Mite still runs strong but the combination brush went missing years ago, this is the tool that puts the machine back to full duty. The 38702-2 is the two-in-one floor and wall brush for Mighty Mite canister models 3685, S3681 and S3686 - the soft-bristle head you use for bare floors and then lift straight up to the baseboards, vents and ceiling corners without stopping to change attachments.
Built for
- Hard floor cleaning. Tile, sheet vinyl, laminate and finished hardwood, where a bristled head sweeps fine grit into the airflow instead of dragging it across the finish.
- Above-floor dusting. Walls, baseboards, door casings, HVAC registers, blinds and the backs of upholstered furniture - the surfaces a floor nozzle cannot reach.
- Light-duty rugs. Passing over low-pile runners, bath mats and fringed area rugs without the risk of pulling fringe into the suction path.
- Keeping an older machine alive. Mighty Mites routinely outlive their attachments. Replacing a lost brush is the cheapest way to get full function back.
Who buys this brush
Most of these go to households running a Mighty Mite that is well past the decade mark and still pulling strong suction. The rest go to small offices, churches and cleaning services that bought Mighty Mites for their light weight and long service life, and to vacuum repair shops that restock the tools customers lose first. In all three cases the machine is fine - it is the accessory that walked off.
Why the combination head matters
A dedicated hard-floor nozzle and a separate dusting brush both work, but you spend the job swapping between them and setting one down where it gets kicked under furniture. The combination brush handles both jobs on one wand, so a room gets floor, baseboard and vent in a single pass. Bristles are also the forgiving choice: unlike a hard-lipped squeegee head, the brush face is the wear surface, so scratching risk on a finished floor stays low.
Specifications
- Type: combination floor and wall brush attachment
- Manufacturer part number: 38702-2
- Stated fitment: Eureka Mighty Mite canister models 3685, S3681, S3686
- Brand: Eureka
If your Mighty Mite carries a model number that is not on the list above, check the diameter of the wand end before ordering and we will confirm the match for you.
Frequently asked questions
Which Eureka models does the 38702-2 fit?
It is listed for the Eureka Mighty Mite canister models 3685, S3681 and S3686. Other Mighty Mite model numbers are common, so check the wand end diameter before ordering and we will confirm the match.
Is this a floor tool or a dusting brush?
Both. It is the combination head, so the same bristled face sweeps hard floors and then works above the floor on walls, baseboards, vents and blinds.
Will it scratch hardwood or vinyl?
The bristles are the contact surface rather than a hard plastic lip, so the brush is the gentler choice on finished floors. Keep the bristles clear of embedded grit and check them periodically.
Can I use it on carpet?
It is a bare-floor and above-floor tool, not a carpet agitator. It will pass over a low-pile rug safely but it will not groom or deep clean carpet pile.
Is this a genuine Eureka part?
It is sold under the Eureka part number 38702-2 for the Mighty Mite attachment set.
Discount Cleaning Products is an authorized dealer for the vacuum and floor care brands we carry, with US-based support from people who work on this equipment every day. If you are not certain this part matches your machine, send us your model number and serial plate details and we will confirm the fit before you order.
