Truck-mount carpet cleaning and restoration crews rely on a rinse gun that can cut through ground-in soil without soaking delicate fibers or blowing out fragile upholstery. The Hydro-Force PowerJet Gun (AS58) from CRW is built for that exact job: a pressure-wash gun assembly with an oscillating nozzle that boosts rinse impact without cranking up pump pressure, so techs get a deeper clean on wall-to-wall carpet, rugs, and pre-treated upholstery while keeping the truck mount running at a lower, more controllable PSI.
Built for
- Truck-mount carpet cleaning rinse-out on wall-to-wall carpet and area rugs
- Pressure-washing hard flooring, tile, and grout ahead of extraction
- Restoration and water-damage jobs needing focused rinse pressure in tight rooms
- Exterior pre-treat and rinse work (entryways, walk-offs, high-traffic mats)
- Techs who need extended reach without dragging a full-length wand through furniture
Specifications
- Oscillating PowerJet nozzle delivers a 15-degree round spray pattern
- Rated up to 2,500 PSI and 202 degrees F
- Includes a 24-inch insulated extension
- Rated flow of approximately 2 GPM at 1,000 PSI
How does the oscillating nozzle increase cleaning power?
The PowerJet nozzle spins a round 15-degree spray pattern instead of holding a fixed flat fan. That oscillation concentrates impact, so running the gun at 1,000 PSI feels and cleans like a conventional flat-spray setup running at roughly 1,500 PSI. It lets techs back off pump pressure on delicate carpet or upholstery while still breaking up embedded soil.
Will this gun work with my existing truck-mount or portable extractor?
The AS58 is a standard Hydro-Force pressure-wash gun assembly built for the connections used on most carpet-cleaning truck-mount and portable rinse setups. Confirm your machine's fitting size and maximum rated pressure before ordering to make sure it matches your system.
What's the maximum pressure and temperature this gun can handle?
The assembly is rated for up to 2,500 PSI and water temperatures up to 202 degrees F, which covers hot-water extraction rigs as well as cold-water rinse setups.
Is the extension long enough to reach under furniture or into corners?
Yes. The gun ships with a 24-inch insulated extension, giving techs added reach for baseboards, stairs, and tight corners without needing to detach and swap wands mid-job.
What causes a pressure-wash gun to leak, and is that covered?
On any pressure-wash gun assembly, the most common wear point is the O-ring or seal at the hose swivel connection, which can loosen or wear down with heavy daily use. Check and hand-tighten that connection regularly as part of routine maintenance to extend the life of the gun.
Discount Cleaning Products is an authorized CRW / Hydro-Force dealer, stocking genuine PowerJet gun assemblies and replacement parts for carpet-cleaning and restoration professionals. Our US-based customer service team can help confirm fitment against your existing truck-mount or portable rinse system before you order.
