The short solution hose on a stainless spotter wand carries pressurized cleaning solution right at the point where the operator flexes the tool thousands of times a week. It is a wear item, and when it weeps, balloons or splits, you get a wet handle, lost jet pressure and a puddle where you did not want one. The Sandia 10-0456 is the genuine replacement hose for the Sandia stainless steel spotter wand — a small part that makes the difference between a tool that sprays properly and one that dribbles.
Built for
- Replacing a split, leaking or ballooned solution hose on a Sandia stainless steel spotter wand.
- Restoring full jet pressure when spray pattern has gone weak or uneven.
- Carpet and upholstery cleaners running Sandia 2- and 3-gallon spot extractors.
- Preventive maintenance on wands used daily, where hose is replaced before it fails on a job.
Diagnosing a pressure loss before you blame the pump
Sandia's troubleshooting guide points to two causes for loss of solution pressure: the pump not working, and a dirty solution intake. Technicians add a third that the manual does not spell out — the hose and fittings between the pump and the jet. The quick field test from the manual is to remove the jet from the end of the hand tool and press the trigger. If flow is strong at the tool with the jet off but the spray pattern is poor with it on, look at the jet and the hose before you condemn a 55 psi pump.
Specifications
- Manufacturer: Sandia Products (Ultimate Solutions)
- Part number: 10-0456
- Type: Replacement solution hose for stainless steel spotter wand
- Application: Sandia spot extractor stainless steel wand assemblies
- Sandia warranty on tools and accessories: 90 days
Sandia's published equipment warranty covers a lifetime on the machine body, two years on vacuum motors and pumps, one year on heaters and electrical components, and 90 days on tools and accessories. Warranty replacement parts must come directly from the manufacturer.
Frequently asked questions
How do I know the hose is the problem?
Run the pump and watch the hose along its length and at both fittings. Weeping at a crimp, swelling under pressure, or a wet handle after a few minutes of triggering all point at the hose rather than the pump.
Will this fit a clear plastic hand tool?
This hose is listed for the stainless steel spotter wand. Sandia's clear plastic hand tools use their own hose configurations and are not rated for machines with heat. Confirm your tool before ordering, or send us a photo.
Do I need new clamps or fittings as well?
Sandia's hand tool parts lists include separate items for the valve, valve clamp, jet and quick disconnects. If any of those are corroded or leaking, replace them at the same time. Call us and we can look up the full breakdown for your tool.
Can I use ordinary hardware store tubing instead?
It is not advisable. This carries pressurized solution and, on heated machines, hot solution. Sandia also states that use of non-manufacturer parts voids future warranty coverage.
Discount Cleaning Products is an authorized Sandia Products dealer. We stock genuine Sandia service parts, not generic substitutes, and our US-based staff can help you confirm the right part number against your machine's model and parts list before you order. Using genuine Sandia replacement parts also keeps your machine's factory warranty intact, since Sandia states that use of non-manufacturer parts voids future warranty coverage.