The brushroll is the part of a Kirby that touches the carpet, and it is the part that quietly stops doing its job. Suction stays strong, the machine still sounds right, but embedded grit is no longer being lifted out of the pile. This genuine 14 inch chevron-style brushroll restores agitation on Heritage and Legend machines, and it carries the belt sensor magnet those models need.
Built for
- Owners of Kirby Heritage II and Legend 2HD machines that no longer lift pet hair from the pile
- Vacuum shops restoring classic Kirby uprights for resale
- Households with pets or long hair where the roller sees heavy wrapping
- Anyone whose green belt indicator light has stopped working after fitting a generic roller
The magnet matters
Legend models use a magnet in the brushroll to trigger the green belt indicator light. A roller without that magnet fits mechanically but leaves the belt light dark, which is the single most common complaint after a generic replacement. This is the genuine roller with the magnet fitted.
Construction and fitment
The roller is made in the USA from hardrock maple with bronze sleeve bearings impregnated with high-grade lubricating oil, and uses extended-life bristles in a chevron row pattern. It fits Kirby Heritage II and Legend 2HD, and is widely listed as fitting Classic, Classic Omega, Classic III, Tradition, Heritage I, Legend I and Legend II machines. It is also referenced under part number 152584G.
Knowing when to replace
- Kirby specifies a minimum of one sixteenth of an inch of bristle protrusion at the set height. Below that, the roller can no longer reach the pile
- Kirby brush rolls mount at three heights as the bristles wear, so step down through the positions before replacing, then replace once you are out of adjustment
- Replace if the roller does not spin freely by hand or the wood shows cracking at an end cap
- Replace if belts are burning through unusually fast, which points to a dragging bearing
Keeping it in service
Cut wrapped hair and thread away with a seam ripper rather than pulling it, since pulling drags the bristle rows out of the wood and damages the bearing seals. Long-time Kirby owners check bristle height and belt condition together, roughly every three to six months on a household machine, and set the brushroll height to the flooring rather than leaving it at one setting year round.
Frequently asked questions
Which Kirby models does this brushroll fit?
Heritage II and Legend 2HD, and it is widely listed as fitting Classic, Classic Omega, Classic III, Tradition, Heritage I, Legend I and Legend II. It is also referenced as part 152584G.
Why does the brushroll need a magnet?
Legend models use a magnet in the roller to trigger the green belt indicator light. A roller without one fits mechanically but leaves the belt light dark.
How worn is too worn?
Kirby specifies a minimum of one sixteenth of an inch of bristle protrusion at the set height. Below that, the bristles can no longer reach into the carpet pile.
What is the roller made from?
Hardrock maple made in the USA, with bronze sleeve bearings impregnated with high-grade lubricating oil and extended-life bristles in a chevron pattern.
How should wrapped hair be removed?
Cut it away with a seam ripper rather than pulling it. Pulling drags the bristle rows out of the wood and damages the bearing seals.
Discount Cleaning Products is an authorized dealer supplying commercial cleaning contractors, facility managers and in-house maintenance teams across the United States. Our US-based staff can confirm fit against your model and serial number before you order, and we stock the companion wear parts most crews replace at the same time.
