This aftermarket brushroll assembly brings worn ProTeam uprights back to full carpet performance without the cost of the genuine part. Built for facility maintenance teams, it drops into the power nozzle of ProForce 1500-series and ProCare 15-series vacuums and replaces ProTeam part 104216, restoring the agitation that lifts ground-in dirt from carpet.
Built for
Use it when an upright starts leaving lint and grit behind or the old brush bristles are worn flat. A fresh 14-inch brushroll renews pickup on high-traffic carpet in offices, schools, and hospitality. Installation takes only minutes with a screwdriver, so a single tech can service several machines in a shift.
Use cases
- Restoring suction and agitation on worn uprights
- Scheduled preventive maintenance on a fleet of vacuums
- High-traffic carpet in offices, schools, and hospitality
Specifications
- Width: 14 inches
- Replaces: ProTeam 104216
- Type: aftermarket brushroll assembly
- Installation: screwdriver, a few minutes
Compatibility
Fits ProTeam ProForce 1500 and 1500XP uprights and ProCare 15 and 15XP uprights.
Frequently asked questions
Which vacuums does this brushroll fit?
It fits ProTeam ProForce 1500 and 1500XP uprights and ProCare 15 and 15XP uprights.
Does it replace ProTeam part 104216?
Yes. This aftermarket assembly is a direct replacement for ProTeam brushroll 104216.
How hard is it to install?
Installation is straightforward and usually takes only a few minutes with a standard screwdriver.
Should I replace the belt at the same time?
It is a good idea to replace the drive belt when you change the brushroll so the new brush spins at full speed.
Discount Cleaning Products offers genuine and aftermarket ProTeam parts with US-based customer service. Contact us to confirm fit or to add a matching belt.